Posted By: BS27ROB
Removing powder coat - 09/18/08 01:16 PM
Is there any way to remove powder coat without marring the substrate? How would the part have likely been prepared for coating? This is on a master cylinder. Do you think it could be returned to an original appearance?
Regular old paint stripper works fine
Posted By: Anonymous
Re: Removing powder coat - 09/18/08 02:40 PM
I've had good luck with Tal-Strip aerosol paint remover.Usually find it a Checker/Cragens/Shuckers.
Posted By: Stanton
Re: Removing powder coat - 09/19/08 03:22 PM
Hot tank.
As long as the part was clean it would have needed nothing else prior to powder coating. The powder isn't that thick so if you don't see casting lines or the rough as-cast finish then it's likely been touched up before it was coated.