SHAKER FEET BOLTS

Posted By: rayztoy

SHAKER FEET BOLTS - 01/08/11 03:54 PM

Hello,
Could someone tell me the size of these bolts and where to source(s) correct OEM? Thank you in advance.

Ray

Attached picture 6404543-4916937-partialshakerfad.jpg

Attached picture 6404543-4916937-partialshakerfad.jpg

Posted By: mccannix

Re: SHAKER FEET BOLTS - 01/08/11 04:39 PM

Ray
Original ones I've removed had this bolt, 7/16 head with an N on it and a 3/4 wide washer. It is 7/8 inch long
Frank Badalson carries shaker feet bolts but I am not sure what is on the head.
The other two in the picture are original grill screw ( S on head... 8 req'd )and original screw that secures rear of cold door to grills ( E on head...2 req'd)
All are black phosphate

Attached picture 6404620-zzzzk2.jpg

Posted By: rayztoy

Re: SHAKER FEET BOLTS - 01/08/11 05:04 PM

Terry,
Thanks for the info!
Ray

Posted By: kidmopar

Re: SHAKER FEET BOLTS - 01/08/11 06:04 PM

Quote:

Hello,
Could someone tell me the size of these bolts and where to source(s) correct OEM? Thank you in advance.

Ray

I have a question regarding part "M" the actual foot piece. Is the bottom of the foot covered with that black "rubberized" coating (like valve cover tabs) or .... what is on there to protect the valve cover? Anyone know?

Posted By: mccannix

Re: SHAKER FEET BOLTS - 01/08/11 06:36 PM

Yes the feet themselves are covered with black rubberized coating as you stated.
The area is shown the diagram provided by Ray.
I should add that I have also seen the same shaker foot bolt used with SEMA on the top

Posted By: gtx6970

Re: SHAKER FEET BOLTS - 01/09/11 05:48 AM

Posted By: rayztoy

Re: SHAKER FEET BOLTS - 01/09/11 03:24 PM

Bill,
Thank you for the pics!

Ray