Moparts

70 cuda hockey stripe location

Posted By: jml19621

70 cuda hockey stripe location - 10/18/10 03:15 AM

I know there is a drawing showing the measurements for the placement of the hockey stripe for a 70 Cuda, I have seen it. I looked in the service manual and the parts manual; however, I cannot find it. Does any one have it? Maybe some one could send me to where I could find it.

Thanks, Jeff
Posted By: Snoopy

Re: 70 cuda hockey stripe location - 10/18/10 03:32 AM



Attached picture 6255773-HockeyStripeDrawing.jpg
Posted By: curious

Re: 70 cuda hockey stripe location - 10/18/10 07:05 AM

Do you happen to have one for 71 billboard?
Posted By: xs29j8

Re: 70 cuda hockey stripe location - 10/18/10 08:37 AM

The NOS Hockey stripe decals have a built in location & alignment aid in the form of an translucent protective covering which is peeled off after the decal is applied. The protective covering overhangs the decal material, and its edges locate to the body "character lines". I do not know if the reproductions use this feature...

Attached picture 6255997-HockeyStickInstall002_800W.jpg
Posted By: xs29j8

Re: 70 cuda hockey stripe location - 10/18/10 08:39 AM

...

Attached picture 6255998-HockeyStickInstall001.jpg
Posted By: Snoopy

Re: 70 cuda hockey stripe location - 10/18/10 08:21 PM

Quote:

Do you happen to have one for 71 billboard?




Attached picture 6256610-71CudaBillBoardDrawing.jpg
Posted By: A12

Re: 70 cuda hockey stripe location - 10/24/23 04:43 PM

It seems to me that the left side stripe in the following photos is more correct than the right side stripe? According to the tech sheet the front edge or beginning of the hockey stripe should be just slightly ahead (1/2"-3/4") of the door handle. The rear of the hockey stripe should be about a 1/2" or so ABOVE the body character line and not any closer or right at it as on the left side. Regardless the left and right are not the same in these photos as done by a certain TV show. I would go by the right side stripe placement or close to it as explained in the tech sheet.

More correct right side with leading edge slightly ahead of the door handle:

Attached picture 20180209_180042.jpg
Attached picture 20180209_180144RS.jpg
Attached picture 6255773-HockeyStripeDrawing (2).jpg
Posted By: A12

Re: 70 cuda hockey stripe location - 10/24/23 04:52 PM

Incorrect left side hockey stripe (IMO) with leading edge Parrell with the door handle opening and the rear of the hockey stick stripe right on the character body line and too much space between the top of the quarter fender line.

(I have to say that the right side stripe was installed by the show's expert and he was showing how it was supposed to be done and it is IMO correct. The left side was done by two of the show's apparentness and they missed it by a little. Just hope the owner of the Cuda doesn't see or read this. wink Sorry but it jumped out at me when I saw it.

MikeR

Attached picture 20180209_180303RS.jpg
Attached picture 20180209_175805RS.jpg
© 2024 Moparts Forums