2 speed to 3 speed wiper motor swap HELP!!!

Hello again all , once again I have another problem though this time electrical. On our resto build we decided to put in a shaker scoop instead of what it came with. We found that it wouldn't fit with the 2 speed wiper motor the car came with, so we bought a 3 speed motor at a swap meet and restored it. Upon installation, we found that the swap wasn't so easy...

The wiring is or course for a 2 speed, along with the switch, so there are going to be obvious problems but I didn't think they were going to be too bad. We have no park, and cannot seem to figure out the high and low speed settings and the ground is in and out depending on how we wire it. Strange... Is it possible for me to take a 3 speed switch, pop in the plug and pop the switch into the dash?? If not, what are my options????

something to remember is the linkages under the cowl are different between 2 and 3 speed

I know the switch is different and only assume the wiring is as well, but the wiring harness may already have the proper wires in the harness

otherwise Jules should be along with confirmation soon

We have installed the proper linkage. Sorry forgot to mention that.

And if a switch is all I need, where would I find one? I have not looked for one before.

This is what I found and have posted before.

Here is a update. I looked in my 69 parts manual and this is what i found.

1-The dash wiring is the same all engines all wiper systems. This is for 69-b-body models.

2- Wiper motor 2 speed-2770090
3 speed 2983116

3-wiper link 2 speed 2631799
3 speed 2822273

4-Bushing 2 speed 2631766
3 speed 2580200

5-Switch 2 speed 3004177
3 speed 2864014

The rest of the linkage ect is all the same.

So I am guessing all I need is a 3 speed switch and I will be ok??

E body 2-3 swap, I assume with the mention of a SHAKER, it's an E body? ....3 speed motor, harness is attached, plug into main bulkhead, you have this plus the correct linkage under the cowl, now you need the 3 speed switch and your done



Check to confirm your switch connector looks like this


If you have problems locating a 3 speed E body switch, I have a "few"...PM me on Moparts


Mike

Hmmm yeah ours doesn't look like that... I might be PM-ing you for a switch or other questions here soon...

Quote:

---

So I am guessing all I need is a 3 speed switch and I will be ok??

---

Maybe.. what car are you working on?