Posted By: ehbody
Seat Back Bumper / Adjuster E-Body - 09/09/18 06:34 AM
Are these still available at Chrysler?
Is the PN 2888-667 ?
Mine just crumbled under the seat.
Thanks
Shawn
Posted By: ehbody
Re: Seat Back Bumper / Adjuster E-Body - 09/27/18 12:28 AM
I got my part.
But the one intact part fell apart when removing.
Does anyone have a picture of their's?
Not sure which way the nylon goes on the bolt.
Thanks
Shawn
Posted By: VCODE
Re: Seat Back Bumper / Adjuster E-Body - 09/27/18 01:03 AM
It can only go on one way. The end with the large opening gets put on the screw. You must heat the plastic up to get it on. A Hair dryer or hot boiling water will work.
Bob
Posted By: Alaskan_TA
Re: Seat Back Bumper / Adjuster E-Body - 09/27/18 01:04 AM
Deep side presses on over the adjusting screw head.
You can look into it, there is a groove it 'pops' into.
Warm it up by soaking it in hot water if you can before pressing it in.
It is not always easy doing it by hand, I actually modified a vise just to make it easy.
Posted By: Alaskan_TA
Re: Seat Back Bumper / Adjuster E-Body - 09/27/18 01:06 AM
I am still wondering if anyone reproduces the black ones yet -
https://board.moparts.org/ubbthreads/ubbt...tml#Post2553320
Posted By: ehbody
Re: Seat Back Bumper / Adjuster E-Body - 09/27/18 01:38 AM
Ok, but does the bolt go thru the bumper?
Thanks for the advise.
Shawn
Posted By: Alaskan_TA
Re: Seat Back Bumper / Adjuster E-Body - 09/27/18 01:40 AM
No.
It sits on the adjuster screw head like the hat on a Mountie.
Posted By: ehbody
Re: Seat Back Bumper / Adjuster E-Body - 09/27/18 02:40 AM
Yeah, I realized this once I pulled the screw out.
Thanks for the Help
Shawn