Kickdown clip broke on my 71 Charger and can't find one???

Hey guys needing some help here. Had a clip on our kickdown break on my 71 Charger and now I can not locate a replacement anywhere. Does anyone know if anyone makes just the clip? I will attach a pic of it below before it broke. It is the clip the holds the kickdown onto the pivot ball of the carb. You can see it here in the pic. ANY help would be greatly appreciated as it is the last thing holding us up on getting her done. Thanks!

Pic of it broken , This is what I need. Thanks

Without knowing the ball/shaft diameters, check with Mr Gasket or Dorman/HELP/MotorMite line for a clip replacement, FYI I'll assume that you know to remove the clip, install the ball into the receiver, then clip it?, I hope it didn't break because you pressed the ball into the clip?

Mike

Does anyone know where to get just the clip??

Go to Doorman's web site and punch in the number, that Dayclona searched, it will come up. It has on it "where to buy". Punch in your zip and you should be good to go

Only place that has "just the clip" is Corvette Pacifica 1800-488-7671 PN# E10325 for a 1/4 ball stud $4.00

Thanks!

Those hands look familiar!!