Moparts

Electrical part question.

Posted By: denfireguy

Electrical part question. - 01/17/09 11:25 PM

This is out of the 8 pin connector to the ignition switch. It is on the dash harness end. The wire is 18 gauge.
Where can you get replacements? I have incinerated ones on the red and black wires.

Thank you.
Craig

Attached picture 4954735-WireConnector(Small).JPG
Posted By: Pacnorthcuda

Re: Electrical part question. - 01/17/09 11:35 PM

Try Napa, or an electrical supply house.
Posted By: denfireguy

Re: Electrical part question. - 01/18/09 12:00 AM

Quote:

Try Napa, or an electrical supply house.



Only one NAPA has is too long. The standard in the electronics industry is Molex and their pins are also too long.
I guess I should have listed where I have looked:
Autozone, NAPA, NAPAonline, EG&G Terminal.
They have them at YearOne, just attached to a 600 dollar harness.
Thanks again.
Posted By: Ashsdad

Re: Electrical part question. - 01/18/09 12:41 AM

When I was an electronics tech my 2 favorite places for terminals were Radio Shack and Mouser Electronics. Between the two I always found whatever I needed.
© 2024 Moparts Forums