Moparts

70 Challenger Hood Hinges - Configuration

Posted By: 72ls5fla

70 Challenger Hood Hinges - Configuration - 03/30/15 11:17 PM

I know that the 70 hoods used a 5/16 bolt with a 1/2 head.
Are the upper part of the hinges that bolt to the side of the hood supposed to have a 5/16 slot or a 3/8 slot?

I know later hoods used a 3/8 bolt 9/16 head.

My hood has the correct bolts, but I seem to remember the slots only fitting that sized bolt in 70.

Why I am asking - I purchased a set that are a take off from a 70 Challenger low mileage car that sat FOREVER. 99.9% sure these are ones installed at the factory.
they have a 3/8 slot not 5/16



Thanks in advance.

Bill
Posted By: RestoRick

Re: 70 Challenger Hood Hinges - Configuration - 04/01/15 12:00 AM

Here's a detail pic of 70 hinges...
quickest id is that 70's have teeth and the narrower width top strap.
Rick

Attached picture 8476586-noted70-4Ebodyhoodhinge.jpg
Posted By: 72ls5fla

Re: 70 Challenger Hood Hinges - Configuration - 04/01/15 01:23 AM

Rick -


MANY THANKS!!

Information and picture greatly appreciated.

Bill
© 2024 Moparts Forums