TA block engine mount ??

I was looking at my engine mount and noticed that this didn't look right.
Is there a bolt / spacer part number that I need?
Thanks

Not a very good picture, sorry.
It is the left hand side rear bolt, that doesn't come thru the nut.

No spacer required, looks like you may have a 318 bracket instead of a 340 mount. You will have to zoom in but you can see it in this picture.

Any way to confirm that?
Besides pulling the mount off.
Are the 318 mounts wider?

Todd I have a pair of the correct mounts if you want to come by and pick them up to compare them with yours.

340 mounts are wider, had to use a spacer between the motor and mount on mine with 318 mounts. 340 mounts were mia at the time.

-Daty