E body seat divider

I fashioned a rear seat divider from the jute insulation that I got from Dante. Nice piece. The question is how low should I go. Right now when the divider is hanging it is over the seat back lower brackets. I know that the bottom will need to be cut off.

Am I correct in assuming that the divider does, in deed, hang from the upper seat back brackets?

'72 Cuda

Thanks

uh good morning, yes it hangs from the seat hooks. Pictured above is a divider not jute

Not sure how close this is to OEM but heres the insulation MARKETS-BEST-1970-1974-Cuda-Challenger-TRUNK-DIVIDER-INSULATION-70-71-72-73-74-

Did the factory ever use shoddy/jute on the divider?