B body wiper bushings - info only

I get asked about these from time to time and thought pictures might better explain it.

The 1968 to 1970 B-body wiper pivots use these square plastic snap in bushings ( I also believe the same era A-bodies use tham as well )

Here goes.
The bushings themselves

And the crank arm end bushing
3 speed on the right
2 speed on the left

The drivers side end. This one has 2 pins and link connections.
The bushings snap into the link arm and then the pin snaps into the bushings.

Top link goes to the wiper motor crank arm
Bottom link goes to the pass side wiper pivot.

Pass side , It just has the one bushing that comes from the drivers side pivot.

The crank arm end - 3 speed version
In an exploded view to see how it all goes together.

Same components, assembled and lubed.

Bill GREAT POST AND INFO


MikeR

Bill,

I did my 68 road runner wiper stuff a few years ago but my 3 speed bushings etc. on the crank arm were a bit different. I found an NOS "kit" on the net and it matched up perfectly with what I had. Have you come across this before? I think the full part # is 2809040.

Jim

It is currently installed on the car and works just fine.

Quote:

---

Bill,

I did my 68 road runner wiper stuff a few years ago but my 3 speed bushings etc. on the crank arm were a bit different. I found an NOS "kit" on the net and it matched up perfectly with what I had. Have you come across this before? I think the full part # is 2809040.

Jim

---

Jim,
sorry, I can't answer that one.
I'm not familiar with the 68's very well. And the '68 Charger I have in the shop is a 2 speed wiper car, so it's no help.
The pics I posted are from a '69 Charger with 3 speed wipers and every piece was indentical to what came off the car.

Jules if your reading this, your more than welcome to chime in