Plug wire config for Doug's headers & Alum 440 heads?

Does anyone have a picture of an engine bay showing the plug wire setup for the combination below ?

Engine: 440
Heads: Edelbrock Performer RPM heads (Angled plugs)
Exhaust: Doug's Headers

I'd like to see the following:
- Plug wire standoffs to keep the wires from burning...
- Straight vs. Angled plug connectors....etc....

Thanks for any help

I'd like to see this too, have a iron headed 440 in a 74 Charger that I would like to refresh with the Eddy's. Not sure what fits.

Post deleted by **MS68EFI**

Sorry -
I'm using Doug's Headers with the big (DOUG's) coin welded to the tube.

I like the screen name. Do you work on anything OTHER than Road Runners?

Ha !

I've actually never owned a RR (yet)...
71 Challenger (383)
69 Coronet R/T (440)
70 Six Pack Challenger (current project)

However a RR may be in my future someday, you never know.

Here's a few from mine using Firecore 50 wires with a little less than 90 degree boots. Edelbrock heads and Dougs D452 headers

Passenger side

Front

Driver's side

Thanks for the picture..
Which plug wires are you using ?

They are Firecore 50 wires from Rich, user sunroofgtx here on Moparts.

Mine are Indy EZ heads and 2" TTI headers but they are angled plugs with the same Firecore wire (which are great plug wires). And they fit great. Ron