Car has Electrical Power but will not turn over

Car has over 12 volts at the Fuse block , the Fusible link (between the connections) at the Red wire from the firewall plug all have ove r12 volts , turn the Ignition switch on and nothing happens , the dash lights up , oil pressure switch is lit , the Car Started before just fine , any suggestions? thanks.

(1) need fire @ the "ign" terminal on the starter relay when you turn the key to start (ign2). (2) the "grn" terminal close to it on the same starter relay needs to be grounded when the trans is in park or neutral. need a jumper wire w alligator clips on each end to check (2) and a helper turning the key to "start" as you check for fire w a test light or VOM for (1).

Take a screw driver and arch between the terminals on the starter relay or on the starter solenoid and see what happens.Make sure that the neutral starter switch wire is hooked up.

It is a 1968 4 Speed Car , everything worked last week , so the only thing I think might be bad is the Battery has a bad cell and when a load is put on the Battery it does not have enough volts / amps to start unless the starter solenoid decided to go bad , I will check all the suggestions , thanks.

In that case make sure that the battery has a good charge and the connections at the battery posts are shiny clean. Remove the cables and scrape both the posts and the cables clean and make sure that they are good and tight

definitely check the NSS.

corrosion/bad contact somewhere..does it crank when u jump the starter relay?

Quote:

---

corrosion/bad contact somewhere..does it crank when u jump the starter relay?

---

I will check that tomorow and also the NSS.