1969 hemi super bee scoops....

I bought a pair of 69 hemi super bee scoops( aftermarket) that did not come with the
Chrome bezels on them. After looking at the scoops. I see the intentions where they go. But ot sure how they
Attach. Can some one explain or possible show pics of how they do attach to the scoops
Also did they get hemi badges on the scoops ?
T.ia.

No such thing as a 'hemi' Scoop for these cars, they are all the same, 383 ect, Scoop would have a Hemi badge on it

Chrome bezels should screw in from the front , phillips head screws , oval head I think , I have to look at my car. There should be 2 holes on the side that faces out that the engine callout badge goes into , it's the same scoop no matter what engine .

.

Here you go.

Hard to tell. But they mount to these 2 studs in front?
And I knew that they would also had 383 emblems
These scoops don't have holes for engine call out but later I would like to put hemi emblems on them
They are going on a ramcharger hood that will be getting a 5.7 swap

No they don't attach to the front studs , they go in the front and held on with 2 screws , one in each upper corner.

If there are no holes they might be off an A body , 340 cars had them in 71 , maybe 70 , and I don't think they had engine call outs

I think the bezels attach to the scoops with a metal capture type clip that the screws go into so they stay on tight. You'll need to buy the chrome bezels and make sure they fit the scoops since they are aftermarket parts, which can be hit or miss.

These scoops came on 70 340 Swingers and they did have both the chrome bezels and the 340 emblems. They were also available on 1971 340 demons as well.

70 swingers did indeed have the bezels and 340 call outs.
i scrapped several of these back in my junkyard ownership days. [1972-1984/85]

I goofed the screw count , only 2 , one on each side into those tabs in front of the 2 forward posts.

Anyone have a nice clear upside down pic showings some detail of the bezel mounting?
Thanks for all the replys

Yes it's a little fuzzy but if you zoom in on Jim Lusk's pic above you can see how the bezel fits and the holes for screws.