Posted By: Checker
Electronics box - 07/10/22 09:50 PM
Is it ok to swap an orange electronics box with a blue or silver. All have the same pin configuration. Thanks moparts...thanks to all in advance
Electronics box
Posted By: Magnumguy
Re: Electronics box - 07/10/22 11:03 PM
I have, as I've done several leanburn to E.I. conversions. I think it depends on manufacturer.
Posted By: Sinitro
Re: Electronics box - 07/11/22 12:58 AM
I think some of the aftermarket boxes from Standard Motor were blue or silver.. But as long as they have the (4) pin connector U should be fine.
However note that I have found that certain ignition boxes have more latency than others so I would recommend that after installing double check the ignition timing.
Just my $0.02...
However note that I have found that certain ignition boxes have more latency than others so I would recommend that after installing double check the ignition timing.
Just my $0.02...
Posted By: moparx
Re: Electronics box - 07/12/22 07:09 PM
as i am aware, most if not all, 4 pin boxes will work.
but as has been mentioned, check your timing, as some boxes can retard timing more than you think.
i don't remember any box that advanced timing, although it may be possible ?
but as has been mentioned, check your timing, as some boxes can retard timing more than you think.
i don't remember any box that advanced timing, although it may be possible ?
Posted By: GomangoCuda
Re: Electronics box - 07/12/22 11:14 PM
Originally Posted by moparx
as i am aware, most if not all, 4 pin boxes will work.
but as has been mentioned, check your timing, as some boxes can retard timing more than you think.
i don't remember any box that advanced timing, although it may be possible ?
but as has been mentioned, check your timing, as some boxes can retard timing more than you think.
i don't remember any box that advanced timing, although it may be possible ?
If you replcaced a box that retarded a lot with one that retarded less the end result would be advanced timing