Posted By: CHRGR69
Fuel Pump Push Rod - 01/19/21 02:12 PM
OK to use a little bearing grease to hold the rod up in place?
Fuel Pump Push Rod
Posted By: Pacnorthcuda
Re: Fuel Pump Push Rod - 01/19/21 02:19 PM
Yes, it’s a common method.
Posted By: moparx
Re: Fuel Pump Push Rod - 01/19/21 06:07 PM
don't be a dummy like me 50 or more years ago.
replacing a fuel pump, and it wouldn't sit flush with the block. no problameo, just crank up the bolts, and CRACK ! followed by a faint "poink".........
took the pump back off, and the actuating arm was missing.............
then i got the opportunity [or "opperchanceity" as my old man put it] to remove the oil pan and remove the chunk of the arm that had found a new home.
it was then i was "learned" about the pipe plug below the push rod and using grease to hold it in position while bolting down the pump.
these days, i forget lots of "stuff", but for some reason, this "lesson" sticks with me............
replacing a fuel pump, and it wouldn't sit flush with the block. no problameo, just crank up the bolts, and CRACK ! followed by a faint "poink".........
took the pump back off, and the actuating arm was missing.............
then i got the opportunity [or "opperchanceity" as my old man put it] to remove the oil pan and remove the chunk of the arm that had found a new home.
it was then i was "learned" about the pipe plug below the push rod and using grease to hold it in position while bolting down the pump.
these days, i forget lots of "stuff", but for some reason, this "lesson" sticks with me............