Posted By: Larry
Ebody R/T hood, 440, and Torker II - 10/22/19 11:44 PM
Is anybody running a Torker II intake with stock dual snorkel 440 Magnum air cleaner on a 440 Challenger with an R/T hood? I am wondering if I can do this without clearance issues.
I looked for previous posts on this, but did not see anything specific to this combo.
Thanks
Posted By: MikeyT
Re: Ebody R/T hood, 440, and Torker II - 10/23/19 04:50 PM
hummm it will be close but I ran a dual snorkel on my 1972 road runner with a 440 and Torker II intake and didn't have any issues with it. I think it should work but it will be close.
Posted By: Larry
Re: Ebody R/T hood, 440, and Torker II - 10/28/19 06:38 PM
Thanks. Any Challenger people out there with this combo??
Posted By: cruzin
Re: Ebody R/T hood, 440, and Torker II - 10/29/19 09:31 PM
Don't have this exact combo. However, according to E-Brock's specs, the Torker II carb pad height is: 4.67" front / 5.20" rear and is 1.7" taller than stock. The more popular, Performer RPB intake manifold pad height is 5.35". Perhaps someone using a Performer RPM can chime in. If you currently have the stock configuration, check to see if you have the 1.7" clearance.
Posted By: RP's R/T's
Re: Ebody R/T hood, 440, and Torker II - 10/30/19 06:05 PM
my car no longer has this set up, but did when I got it.
440 Torker with 850 Holley. Aftermarket aircleaner.
Posted By: Greentween
Re: Ebody R/T hood, 440, and Torker II - 10/30/19 11:49 PM
Challenger, r/t hood, 440, RPM intake requires drop base aftermarket air cleaner and it is a close fit. So no way with stock air cleaner with the RPM.