Moparts

Specs on this Crower cam?

Posted By: Jeff_383

Specs on this Crower cam? - 03/09/18 04:01 AM

Can anyone give me the specs on this cam? I can't seem to find them anywhere.

Attached picture 2018-03-08 20.58.54.jpg
Posted By: 71birdJ68

Re: Specs on this Crower cam? - 03/09/18 04:36 AM

Can't read the part number.
Posted By: Cab_Burge

Re: Specs on this Crower cam? - 03/09/18 04:39 AM

Call Crower tech. @ 619-661-6477 to get the straight scoop up
They're very helpful scope
Posted By: Jeff_383

Re: Specs on this Crower cam? - 03/09/18 04:45 AM

#80132
Posted By: Cab_Burge

Re: Specs on this Crower cam? - 03/09/18 05:40 AM

Call them with all the numbers etch into the ends of the cams scope , that will give them the lobe separation angle and probably which lobes are on that cam thumbs
Posted By: Jeff_383

Re: Specs on this Crower cam? - 03/09/18 06:38 AM

No numbers on cam
Posted By: 451Mopar

Re: Specs on this Crower cam? - 03/09/18 07:53 AM

Originally Posted By Jeff_383
#80132


Most of the #80xxx, and #81xxx numbers are the lifter, spring, retainer kits? Re-looking at the photo, it says component kit which is the lifters, springs and retainers, but not the cam. In the 1980 price guide it says it cost $297.00 List, $207.90 User.
I looked through the 1980 Catalog I have, but it does not show that part number? It may have been a Component kit part number before 1980?

If you have a block to put the cam in, and a cam degreing kit, you cam measure the specs off the cam.
Posted By: Cab_Burge

Re: Specs on this Crower cam? - 03/09/18 09:33 AM

Originally Posted By Jeff_383
No numbers on cam

If it doesn't have Crower etched into the cam with the grind number and LSA on it then it is probably not a Crower cam, even though it was in a Crower box shruggy work
© 2024 Moparts Forums