AC clutch removal- RV2????? Help!

How can I do this without the Miller tool?

I don't want to damage the good one I have.

Thanks

Have you checked with your local parts stores for a tool rental?

https://board.moparts.org/ubbthreads/ubbthreads.php/ubb/showflat/Number/6683751/site_id/1

Taps off with a hammer! Good link. Thanks

I agree.Every one Ive pulled just undo the nut and tap with a rubber or dead blow hammer.Never had one that didnt come off.Rocky

If my memory serves me correctly, you screw a big bolt in it and it just presses against the shaft and comes right off.

I'll confirm what others above have said.
Sit down.
Hold compressor with clutch facing down over your lap.
Tap the clutch a couple of times on the side.
Give a healthy tap on top of the compressor.
Catch clutch in lap.
Note: FSM says new clutch bearing must be used whenever clutch is removed.
I'm not saying that. The FSM says it.

A k frame mounting bolt works perfectly to remove the clutch pulley from an rv2 compressor. It is the right thread pitch and right length.