Moparts

trunk lid decal

Posted By: raybee

trunk lid decal - 06/17/17 06:28 PM

Getting eady to install the trunk lid decal on my 70 roadrunner, is there a certin measurment from the top and bottom lines or just center it? also on the 440-6 decal on the hood? thanks for the help.
Posted By: stumpy

Re: trunk lid decal - 06/17/17 06:46 PM

Which decal?
Posted By: raybee

Re: trunk lid decal - 06/17/17 07:19 PM

The decal that goes from rear quarter extension to the other quarter extension
Posted By: DAYCLONA

Re: trunk lid decal - 06/17/17 11:46 PM

.

Attached picture rrtese44.JPG
Posted By: DAYCLONA

Re: trunk lid decal - 06/17/17 11:53 PM

...

Attached picture 70_GTX_RR_Hood.jpg
Posted By: DAYCLONA

Re: trunk lid decal - 06/18/17 12:12 AM

If your decal backing paper looks like this below? then the location is already determined for you, the red arrows indicating where the white backing paper of the decal lines up with the airgrabber door opening on the hood to locate the decal properly, just double check that the actual 440-6 lettering of the decal will "fall" within the main stripe on the hood and not too close on the edge of the stripe, make adjustments as needed...IIRC I gave you the hood stripe location several months ago?...good luck with your project

Mike

Attached picture rr4406decal.JPG
Posted By: raybee

Re: trunk lid decal - 06/18/17 05:19 PM

THANK YOU DAYCLONA, you have helped me out a lot on my restoration over the past 2 years
© 2024 Moparts Forums