Okay, dumb question. How hard is it to remove the dog dish hubcap without scratching/damaging the finish on the wheel? Is there a tip to doing this? Thx
I found an L shaped piece of scrap metal, put tape on the part that touches the wheel and pried the suckers off. Tougher putting them back on without denting them.
i made one similar to that using a long, junk screwdriver i heated and bent into a J shape, then coating it with several layers of plasti-dip. i still use a soft cloth doubled up as a backer on the wheel surface. sorry i don't have a pic, but it is a very simple and cheap tool to make.
I'm lazy and used a little wheel bearing grease on the tabs before I put the hubcaps on. Made it easier for me to get the caps off/on with the plastic/nylon tools and a rag. Don't use too much grease cause it will sling off.