Posted By: Carsavior
Old auto trans faskets - 02/27/17 02:09 AM
Looking for the gasket that goes on the cover where the shift cable goes into the tranny on a 65 Chrysler. Any sources?
Old auto trans faskets
Posted By: John_Kunkel
Re: Old auto trans faskets - 02/27/17 08:05 PM
There is no gasket on the shift cable but the rubber O ring is .700" OD X .100" thick.
Posted By: Carsavior
Re: Old auto trans faskets - 03/03/17 05:46 AM
Small aluminum box approximately 2 inch by 5 inch. Bolts to bottom of trans. One cable goes into it. Need the gasket for it.
Posted By: Cab_Burge
Re: Old auto trans faskets - 03/03/17 08:54 AM
It sounds like someone has put a older cast iron torqueflyte in that car 
Does the cast iron transmission case bolt into the aluminum bell housing?
If so you have a early cast iron tranny in that car, not a 727 like should be in it
Does the cast iron transmission case bolt into the aluminum bell housing?
If so you have a early cast iron tranny in that car, not a 727 like should be in it
Posted By: 52savoy
Re: Old auto trans faskets - 03/03/17 09:08 AM
Originally Posted By Cab_Burge
It sounds like someone has put a older cast iron torqueflyte in that car
Does the cast iron transmission case bolt into the aluminum bell housing?
If so you have a early cast iron tranny in that car, not a 727 like should be in it
Does the cast iron transmission case bolt into the aluminum bell housing?
If so you have a early cast iron tranny in that car, not a 727 like should be in it
Cab, I think your forgetting the parking lock housing that were on early 60s TFs. I don't know if you can buy one of those gaskets separate. Probably easier to make one.
LINKY
Posted By: Cab_Burge
Re: Old auto trans faskets - 03/03/17 07:38 PM
Originally Posted By 52savoy
Originally Posted By Cab_Burge
It sounds like someone has put a older cast iron torqueflyte in that car
Does the cast iron transmission case bolt into the aluminum bell housing?
If so you have a early cast iron tranny in that car, not a 727 like should be in it
Does the cast iron transmission case bolt into the aluminum bell housing?
If so you have a early cast iron tranny in that car, not a 727 like should be in it
Cab, I think your forgetting the parking lock housing that were on early 60s TFs. I don't know if you can buy one of those gaskets separate. Probably easier to make one.
LINKY
Your probably correct on this
OP, are you looking for that gasket?
Posted By: John_Kunkel
Re: Old auto trans faskets - 03/03/17 07:51 PM
Posted By: PC-CHARGER
Re: Old auto trans faskets - 03/03/17 10:39 PM
Send me a PM with your name and address and I'll mail one out to you.
Posted By: bboogieart
Re: Old auto trans faskets - 03/04/17 12:49 AM
Originally Posted By John_Kunkel
Park housing gasket.
So that's for the park brake.
I scrapped out a 65 New port a few years back.
I also thought that was the shifter cable.