How to Determine the Correct Speedometer Gears?

Hello all!

I have to throw this out there as I'm not having any luck in finding out the correct speedometer gear for my application.

Here's what I am working with.

Trans: A833 4-spd
Dana rear: 3.54:1
Tires: P245/60R14

Any information as always is greatly appreciated.

Thanks!

the chart is located in the tech archive section.

http://www.moparts.org/Tech/tech/pages/speedo.html

An old rule of thumb is each tooth is worth 2mph.

in a parking lot make a paint mark in the middle of the tread at ~8 O'clock then roll the car forward straight ahead (~8 ft) till it leaves another mark & tape measure that distance (rollout) then divide Pi (3.14) into that number to get the exact dia then go to the archives chart along with your gear ratio (locate the chart that goes down to the tenths of an inch IE 26.2. jack up the car way high on the dr side to minimize fluid loss & be sure to clock the adapter on the side of the trans correctly for the number of teeth pinion you will be using.

Thank you very much!

that be the one!