Are these spindles any good?

I bought these years ago, they are E-body pieces and I want to install them on my 69 B-Body for my disc brake conversion.

I am a little concerned with the rust on bearing surfaces.
Looks like surface only should I be worried or just clean them up and go? What is the best way to clean them?

Or should I just call em a loss and get new ones?

Plaz

OK now with a link to the picture

https://www.dropbox.com/s/hd8fzfkdt3q92q8/Spindles.jpg

Thanks
Plaz

Pic didn't show so I'm not sure, see if it cleans up and see how well the bearings fit. Went thru this a few years ago, as long as there is no pitting you should be fine.

-Daty

try some fine grit emery paper and varsol. I think it will clean up ok.

Those are fine, the bearings ride on races anyway.

Quote:

---

Those are fine, the bearings ride on races anyway.

---

the only critical point is the area where the inner wheel seal rides....