Hand e-brake lever

I am going to have to install a hand style e-brake lever in my GTX. I have enough room between the driver seat and the door sill to install something....appx4" on the flat of the floor and another 3"or so to the door panel. About 7" total from the edge of the seat to the door.
Any ideas as to a particular brand or model?

IIRC, the e-brake handle on my sister's '04 Jeep GC is mounted on the right side of the trans hump as part of the console. Might work OK where you're thinking of locating it. The handle is nice looking, so that's a plus. Don't know about the specific mount arrangement though.

The one in wife's '92 Acura Vigor (only built between '92 and '94, but later RS's and RL's wre similar) is mounted on a flat on the tunnel hump, so that's a possibility, too. Leather (looking) handle and leather boot. Usually black.

Great excuse to go meandering through the JY, IMO.

Just curious - how you going to route the cable to the passenger side?

this is an A-body with a lokar E-brake.

The Aussie Charger had the hand brake in that location from the factory...well, between the door and door panel, just the other side of the car

I have a spare handle around I can get a pic of tomorrow if you'd like.

That would be awesome OZ, thanks.

I have a Lokar setup like West shows. I am a little concerned about drive shaft clearance, hopefully it will clear with a 1350 slip yoke and 3" shaft.

It should clear fine. You will have to remove the drive shaft to make adjustments though. Id like to have one that has the cable come up into the interior.

Quote:

---

It should clear fine. You will have to remove the drive shaft to make adjustments though. Id like to have one that has the cable come up into the interior.

---

FWIW, the lever, ratchet, mount, balance bar, and cables are all on the interior on the Vigor, then the two individual cables pass through the floor to the calipers. Hasn't required any adjusting, but the console is easy to remove - shifter knob, and four screws.