Glad to join this forum. Quickly scanning it looks like a lot if knowledgeable people. I have been building a couple 67 Plymouth Belvedere II’s over the years.

#1 67 all original paint interior. Built 340 904 3.23 Suregrip.

#2 67 Silver Special. As of now I’ve done subframe connectors, driveshaft loop, sway bar, carpet.

#3 66 Coronet parts donor to get the Silver Special where it should be. Will be 440 727 3.23 SureGrip.

Love these B Bodies…both are super clean cars.

Some more..

Oh wow, another '67 Plymouth B-body nut!!! And I thought. I was the only one. Nice rides.

Thank You…I love the 66-67’s toughest cars around.

Continuing to harvest parts of the old 66. Began prepping the 8 3/4..727 is out..Big Block is out and ready to be stripped. K Member coming out tomorrow. Also got a dash pad out with zero cracks.

A few more randoms

All stripped out….

Bonus points in my book for fixing up a 4 door! Love the plate!

Both cars are cool!

Thanks !! The 4 D in the B5 gets a lot of attention

Sold the parts car shell…cleaning up all the parts for the Big Block swap..ordered Cal Tracs..8 3/4 is going in soon..

7 1/4 out 8 3/4 in place.

Cal Tracs installed..homemade bushing press out of some 1/2 inch threaded rod, some washers and a couple iron pipe flanges. Works good 2nd set of Cal Tracs I’ve installed with it.

8 3/4 install and Cal Tracs is complete. Pulling the motor and trans next the. The V8 K Member is going in.

Motor and trans pulled…next is the k member swap.

V8/BB K Member is in with BB torsion bars…wasn’t a bad job. I normally paint up the trans cross member found this one with old swap meet pricing on it so I’m going to leave it. I clear coat over the center chuck to save the factory paint markings, I also left the paint marks on the torsion bars.

Bent up the rear brake lines..

Hurst shifter test fit

On the road spring of '23?

Potentially..I have to source the 440, short block at least. I’m relocating to Georgia after next summer so it may be complete minus the motor until I get settled.

Switched gears a little, a Mopar buddy of mine had a 383 HP short block from a 69 Roadrunner that’s going to do the job well. Nice factory cross hatch low mileage motor. Trickflow Alumimum heads and a nice nice cam incoming..