Electric water pumps
#3051973
06/20/22 12:32 PM
06/20/22 12:32 PM
|
Joined: Dec 2005
Posts: 11,524
Fulton County, PA
CMcAllister
OP
Mr. Helpful
|
OP
Mr. Helpful
Joined: Dec 2005
Posts: 11,524
Fulton County, PA
|
Pulling the old Moroso heater motor kit from a Stocker project for an electric unit.
Leaning Meziere. Who makes the best one these days? Reliable, flow, pressure. Cost is not an issue. Failing in late rounds is.
If the results don't match the theory, change the theory.
|
|
|
Re: Electric water pumps
[Re: CMcAllister]
#3051977
06/20/22 12:52 PM
06/20/22 12:52 PM
|
Joined: Jan 2003
Posts: 11,707
Portage,michigan
B3422W5
I Live Here
|
I Live Here
Joined: Jan 2003
Posts: 11,707
Portage,michigan
|
Most people will say Meziere I would guess, but in 20 odd years now running the billet Moroso electric water pumps on small block’s I have never had a failure .
Cool well between rounds, 12 or 16 volt, pump plenty of water even for street use which I often do.
So sold on the reliability at this point you couldn’t give me anything else
69 Dart GTS A4 Silver All steel, flat factory hood, 3360race weight
418 BPE factory replacement headed stroker, 565 lift solid cam
Best so far, 10.40 @127 1/4
1.41 best 60 foot
6.60 at 103.90 1/8
|
|
|
Re: Electric water pumps
[Re: B3422W5]
#3051991
06/20/22 01:45 PM
06/20/22 01:45 PM
|
Joined: Dec 2005
Posts: 11,524
Fulton County, PA
CMcAllister
OP
Mr. Helpful
|
OP
Mr. Helpful
Joined: Dec 2005
Posts: 11,524
Fulton County, PA
|
Failed to mention, going on a BB Ferd. Weight is also a consideration.
If the results don't match the theory, change the theory.
|
|
|
Re: Electric water pumps
[Re: CMcAllister]
#3052035
06/20/22 03:57 PM
06/20/22 03:57 PM
|
Joined: Jan 2003
Posts: 13,354
Marion, South Carolina [><]
an8sec70cuda
I Live Here
|
I Live Here
Joined: Jan 2003
Posts: 13,354
Marion, South Carolina [><]
|
Still running the same Meziere pump on my hemi that I put on it in 2008.  The Camaro had a CSI/CSR on it that was around 12 years old before it died. Replaced it w/ a Meziere that's now 8 years old or so and still going strong.
CHIP
'70 hemicuda, 575" Hemi, 727, Dana 60
'69 road runner, 440-6, 18 spline 4 speed, Dana 60
'71 Demon, 340, low gear 904, 8.75
'73 Chrysler New Yorker, 440, 727, 8.75
'90 Chevy 454SS Silverado, 476" BBC, TH400, 14 bolt
'06 GMC 2500HD LBZ Duramax
|
|
|
Re: Electric water pumps
[Re: jwb123]
#3052040
06/20/22 04:23 PM
06/20/22 04:23 PM
|
Joined: Jan 2003
Posts: 8,021
Tulsa OK
Bad340fish
master
|
master
Joined: Jan 2003
Posts: 8,021
Tulsa OK
|
Mezziere here as well, I did have a problem with it when it was 15 or so years old. I sent to to them, they inspected it, called it dead, and had me a new one shipped within an hour of my UPS tracking notifying me that they received it. It of course was out of warranty at that age but they were quick to diagnose it and get one heading back my way.
68 Barracuda Formula S 340
|
|
|
Re: Electric water pumps
[Re: Bad340fish]
#3052048
06/20/22 05:11 PM
06/20/22 05:11 PM
|
Joined: Jan 2003
Posts: 2,915
A shed in England
Tig
master
|
master
Joined: Jan 2003
Posts: 2,915
A shed in England
|
Been using a Meziere WP 105 successfully for some time (the one that fits in the stock pump housing) It's been in 3 engines, likely over 15 years old now I think about it. I have a S/H spare just in case. Gets my vote
'74 Challenger..9.46 @ 145.9 1/4, 6.001 @ 118 1/8 so far. 4023lb !!! # N/A, Marsh performance 655ci, Indy Maxx, T/R, Indy 600-13 X's, Street legal, pump gas, full interior, Cal-Tracs, mufflers, 3:73's and real 10.5 radials.
9.51 @ 142.4 1/4, 6.003 @ 114 1/8 with our old mule KB, 572-13, 580 wedge.
RHD '68 Barracuda Fastback 323ci street/strip. Best ET 13.88 @ 99.03
|
|
|
Re: Electric water pumps
[Re: Sammy]
#3052147
06/21/22 10:15 AM
06/21/22 10:15 AM
|
Joined: Apr 2007
Posts: 47
S.E. Michigan
TruPerformance
member
|
member
Joined: Apr 2007
Posts: 47
S.E. Michigan
|
Does the Meziere WP105S fit in the stock type aluminum housing? I assume that the aluminum is the same as a stock cast housing, but just checking before ordering....
1963 Belvedere (mine)
1969 Roadrunner (wife's)
|
|
|
Re: Electric water pumps
[Re: CMcAllister]
#3052148
06/21/22 10:16 AM
06/21/22 10:16 AM
|
Joined: Jan 2003
Posts: 8,021
Tulsa OK
Bad340fish
master
|
master
Joined: Jan 2003
Posts: 8,021
Tulsa OK
|
Sold. Meziere in the mail. If you have never had your hands on one you will be impressed, they are a beautiful piece.
68 Barracuda Formula S 340
|
|
|
Re: Electric water pumps
[Re: TruPerformance]
#3052152
06/21/22 10:40 AM
06/21/22 10:40 AM
|
Joined: Jan 2003
Posts: 2,915
A shed in England
Tig
master
|
master
Joined: Jan 2003
Posts: 2,915
A shed in England
|
Does the Meziere WP105S fit in the stock type aluminum housing? I assume that the aluminum is the same as a stock cast housing, but just checking before ordering.... No issues on mine, old M/P aluminum one. D/S inlet. HTH's
'74 Challenger..9.46 @ 145.9 1/4, 6.001 @ 118 1/8 so far. 4023lb !!! # N/A, Marsh performance 655ci, Indy Maxx, T/R, Indy 600-13 X's, Street legal, pump gas, full interior, Cal-Tracs, mufflers, 3:73's and real 10.5 radials.
9.51 @ 142.4 1/4, 6.003 @ 114 1/8 with our old mule KB, 572-13, 580 wedge.
RHD '68 Barracuda Fastback 323ci street/strip. Best ET 13.88 @ 99.03
|
|
|
Re: Electric water pumps
[Re: Tig]
#3052169
06/21/22 12:12 PM
06/21/22 12:12 PM
|
Joined: Jan 2003
Posts: 19,360
Las Vegas
Al_Alguire
I Live Here
|
I Live Here
Joined: Jan 2003
Posts: 19,360
Las Vegas
|
IMO you made the right choice. i have one thats been in one of my hoopties since 2000.Only had an issue once and as stated they had it fixed and back to me the next week.
"I am not ashamed to confess I am ignorant of what I do not know."
"It's never wrong to do the right thing"
|
|
|
|
|
