NOS/Assembly Line 2602722 Jack Hold Down Spring


This is the only correct finish and configuration, unlike the reproductions!


39.00 plus shipping. PayPal preferred.


Bill Rolik


bremotorsports@verizon.net


201-394-5533 Cell/Text

Mopar 53032456AE Bell Crank, this is the part needed to convert manual gas pedal to drive by wire and maintain kick down functionality needed for the 904/727/518 transmissions behind a 3G Hemi.
Fully tested and functional, includes the wiring harness, $125 includes shipping to US
Also have just the sensors for $100, if you don't need the housing.

Here’s a link on how to set-up:

https://www.youtube.com/watch?v=5H6Jt6G5DcA&t=197s&ab_channel=DIYHEMI

Rear trailer tie down brackets for most A, B, or E body vehicles (doesn’t fit the 7 ¼ rear axle). These piggyback onto the bottom of the stock shock plate mounting nuts and then 4 more nuts hold these tie down brackets on. You must have enough extra thread hanging down on the bottom of your U-bolts to fit the ¼” thick tie down bracket and another nut. No disassembly necessary, just slide the brackets over the extra thread on your U-bolts, install the included nuts, tighten them down and you’re done. Takes about 10 minutes to install. These eliminate all the hassles that come with using axle straps. Fits A, B, and E body cars with the standard shock plates like shown in the pictures. $60.00 per pair plus shipping. I also have these available for cars with CalTracs, same price.
Email mrrandyj@aol.com

For Sale;
Nice pair of hood hinges off of a 1969 Road Runner. $50.00. plus shipping.
3 sets of B-engine mounts, 2 with bolts, $45.00. Pair without bolts, $35.00. Plus shipping.
PM or call/text 406-489-3534.
Thanks for add, Moparts. Jim.

NOS Charger Roadrunner AC alternator pulley, part number 2875711, correct double AC pulley, never installed, mint condition, $100

NOS 62-70 B Body headlights, Westinghouse 4001 Hi beam, correct early headlights, tested good in the original box's, mint condition, $25 each

NOS 1970 Roadrunner Charger Hemi engine harness, mint condition in the original Chrysler box

Original Chrysler starter housing, part number 209150, 12th week of 1967 dated, correct for a late 1967 or early 1968 car, 318-383-440, excellent condition, $50


Email Kenei@comcast.net

SOLD..SOLD...SOLD....

VERY NICE LOOKING 70 B BODY AM/FM... SADLY IT DOES NOT WORK... [I HAVE KNOBS ALSO] GREAT CANDIDATE FOR UPGRADE TO SOLID STATE CURRENT BLUE TOOTH TECHNOLOGY WHILE RETAINING ABSOLUTE ORIGINAL LOOK... YOU KNOW HOW RARE THESE ARE.. $ 1200.00 + 25.00 SHIP USA WELL PACKED..

All B-Body:

66-70 Console Assemblies $845+up,

Set 1968 Dodge Dogdish Hubcaps $395-$475,

68-70 Maplight $75,

1969 Road Runner Parklamp Housing $95,

1970 Road Runner Tiebar/Front Valance $295,

1970 Road Runner Lower Grill $125,

1970 Road Runner Tiebar/Front Valance Stainless Molding $145,

1970 Road Runner Hood Latch Mechanism $95,

3.55-1 Sure Grip 8-3/4 Pumpkin $995,

68-69 round unsilenced HP air cleaner $195,

Big block PS pump and brackets $145,

Restored 1970 440-HP #3438222 Distributor with NOS Vacuum Advance Unit $445,

NOS 340-383-440 air cleaner pie tins $95+up

383 and 440 Edelbrock Torker Intake Manifolds $195-$225,

68-71 Big Block Valve Covers $195-$255,

Tuffwheel Adapter $115,

Check Out Our New Webstore at tonysparts.com
302-398-0821,
contact@tonysparts.com
Tonys Parts
Harrington Delaware 19952

Right quarter glass assy from 1969 Road Runner
$100 plus ship
PM for more info please

Glovebox door with lock from 1969 Road Runner

$60 plus ship
PM for more info please

Trunk latch with lock from 1969 Road Runner
$50 plus ship
PM for more info please

Radio bezel from 1969 Charger
"ported" for aftermarket radio
$20 plus ship
PM for info

2898334 Grille Ornament no salt pitting 25.00 each have 6
2901751 Coronet Fender nameplate perfect condition 15.00 each have 5
2841634-5 R/L Qtr Window innner belt weatherstrip retainer 10.00 each SOLD!
Stamped with EM 38R or EM 38L
2932190-1 R/L Qtr window belt molding 43.00 each SOLD!
no dents. fits all 1969 Coronet convertibles


shipping extra

www.arizonaparts.com

480-966-6683

mkolner14@hotmail.com

All New 1970-1971 B+E-Body 383 + 440 High Performance Exhaust Manifolds!!

Casting #s 2899879 Right (Passenger) Side + 2951865 Left (Drivers) Side
These Are Licensed Through Mopar And Have All Of The Factory Markings!

Heat Riser Valve Assembly Is Installed And These Are Ready To Bolt On!

Available In 3 Date Codes 8-1969, 1-1970, 8-1970
+ Also With No Date As Some Manifolds Were Produced That Way Too!

$695 Per Pair

We Have A Limited Supply Of Right Side Exhaust Manifolds Available For $395 Each,
We Also Have The Installation Bolt Kit Sets For $40.
In Stock And Ready To Ship

Check Out Our New Webstore at Check Out Our New Webstore at tonysparts.com
302-398-0821,
contact@tonysparts.com
Tonys Parts
Harrington Delaware 19952

Nice fluxed driver side exhaust manifold. Strong date code 225.00

These hold the top material to the well of the car.These are hard to find,18 of them.$40 for what you see pictured.Calls only.603 209 1678.Payment by US POSTAL money order only

New transmission polyurethane mount for 63 to 65 automatic. Two studs on top and 2 holes at 4" center. Asking $60, includes shipping.

One set of resprayed OEM (used) Production Line Installed caps. BBP.

why waste time and OE paint on old used caps?

These still have amazing chrome for their age. Survivor quality, no gouges, no blistering in the bright areas (only minor spotting), but do have some slight minor pitting in the painted areas.

These are what i call 3-5 foot show quality. Or 1ft if you consider their age and what you'd find on a high quality barn find..

Unlike most caps you see on "OE" restored cars, these have the correct bright "white" silver Argent vs the dull faded gray/yellowed paint someone tried to eye matched from 40 plus year old parts.

Old Paint was stripped, corroded stud threads repaired with Helicoil inserts as needed

Aluminum spun inserts are Included and installed (not on at time of pic). Plus they are older FPAP inserts, which are actually made and spun on center.

425.00/set, Plus shipping (UPS Only).

Paypal F/F only, Or, old school money order.

PM your email, I'll get a notice... Not online that much these days (so response may not be instant)

Have a nice drivers side exhaust manifold with a strong date code. It has been fluxed and found no cracks. 225.00 plus the ride