Previous Thread
Next Thread
Print Thread
Cuda 5.7 //////harness to Rally dash tach #2908054
04/08/21 03:07 PM
04/08/21 03:07 PM
Joined: Apr 2005
Posts: 833
Ohio
V
viperakron Offline OP
super stock
viperakron  Offline OP
super stock
V

Joined: Apr 2005
Posts: 833
Ohio
Bought a running 73 Cuda with a Gen 3 5.7 conversion. It has an interface done on all the other gauges in the stock rally dash. Was told to buy a MSD 8910 tach conversion module. Anyone wired up stock tach to gen 3 harness? Looks like I've got a violet wire in the 5.7 harness that sends a tach signal. Is the 8910 the correct conversion piece? Can anyone help with what goes where to make it work.

IMG_3919.jpg
Last edited by viperakron; 04/08/21 03:25 PM.
Re: Cuda 5.7 //////harness to Rally dash tach [Re: viperakron] #2911577
04/18/21 11:35 AM
04/18/21 11:35 AM
Joined: Jan 2021
Posts: 948
rust belt
M
Moparite Offline
super stock
Moparite  Offline
super stock
M

Joined: Jan 2021
Posts: 948
rust belt
Quote
It has an interface done on all the other gauges in the stock rally dash.

I am assuming this converts can-buss to conventional? Would need to do the same with the tach if that's what the msd does.







Powered by UBB.threads™ PHP Forum Software 7.7.1