Just put a pair of doors on a 21 Ram that hit a deer. They naturally are new door shells. Nothing damaged on the doors as far as regulators or anything like that. Just a swap of parts after they were painted. The front door has the auto up/down function. Usually the rest process has always been roll it all the way down and hold the button in the down position for 3-5 seconds. Then roll it up and repeat. I tried that multiple times with no success. When you hit the button up or down it will roll up or down about 1-2 inches then stop. Didn't matter if either hitting the button once or trying to hold it. It only moved that much either way. I tried having the door open and having the door shut doing the usual reset function and no luck. Anyone ran through this process?

Thanks

corey

leads?

put the window to the bottom - raise the window and hold the "up" button all the way up for three seconds after the window stops moving - lower the window and hold the "down" button all the way down for three seconds after the window stops moving - raise the window and hold the "up" button all the way up for three seconds after the window stops moving.

Nope tried that normal reset trick but no success.

corey

I read what you wrote but if what you did what you wrote you forgot the last step. Read what I wrote carefully.

Ok So every time it stops moving just repeat the 3 second hold? If it is down and moves up just an inch or so. Keep that process going up then same going down?