727/904 nss hole size - Moparts Forums

Register Log In Moparts Forums Unlawfl's Race & Engine Tech 727/904 nss hole size

Print Thread

727/904 nss hole size #2802954 07/30/20 03:29 PM 07/30/20 03:29 PM
Joined: Aug 2011 Posts: 127 Az H HOT IN AZ OP member
HOT IN AZ OP member H Joined: Aug 2011 Posts: 127 Az	Looking for the tap/die size for a 727/904 neutral safety switch. Thinking of making a shifter activated switch out of one. Micro switches are nice but seem too fragile. Thanks in advance...Rick!

Re: 727/904 nss hole size [Re: HOT IN AZ] #2803012 07/30/20 05:54 PM 07/30/20 05:54 PM
Joined: Oct 2010 Posts: 2,404 Ambridge, Pa. R rickraw top fuel
rickraw top fuel R Joined: Oct 2010 Posts: 2,404 Ambridge, Pa.	I measured the shank on n old switch, 665 thou. Thread pitch is 16. Threads are straight cut. Maybe 11/16 drill.

Re: 727/904 nss hole size [Re: HOT IN AZ] #2803267 07/31/20 12:30 PM 07/31/20 12:30 PM
Joined: Jan 2003 Posts: 25,720 Rio Linda, CA John_Kunkel Too Many Posts
John_Kunkel Too Many Posts Joined: Jan 2003 Posts: 25,720 Rio Linda, CA	The thread is 3/4"-16 same as AN-8. The INTERNET, the MISinformation superhighway

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1