Can you weld?

Bolt a couple of pieces of angle iron onto the bumper bracket holes like the Car Tool piece does. But instead of a metal spreader, use a 2x4 and pull from the ends of the angle iron with a chain. That way all you need is a drill and bit for a few well placed holes.

I know that will work because I have done it myself.

Bolt a couple of pieces of angle iron onto the bumper bracket holes like the Car Tool piece does. But instead of a metal spreader, use a 2x4 and pull from the ends of the angle iron with a chain. That way all you need is a drill and bit for a few well placed holes.

I know that will work because I have done it myself.

Use 1/4" angle. I used 1/8" at first but it flexed when moving the front end around with the engine installed. 1/8" was fine when lifting just the body.

I picked the front of the car up using the motor plate tabs that are welded to the front frame rails.

AndyF, I like your idea. Looks like you have the chain suspended from your ceiling. How high of a ceiling do you have in your shop/garage? Looks like you have plenty of clearance.

David