Hi all, just wondering if anybody makes those little foam gasket that go between the brake back plates and front spindles ?

Later, BuZZ

Yes, detroit muscle tech has them https://www.detroitmuscletechnologies.com/mopar-73-76-disc-brake-spindle-to-backing-plate-gasket/

https://www.detroitmuscletechnologies.com/mopar-66-72-disc-brake-spindle-to-backing-plate-gasket/

I make mine from some white packing sheet foam and a utility knife. Lay backing plate on foam, trace inner hole and add about 3/4" for outer circumference and cut. Nice gasket. Looks just like factory. (you can't see it)

I have made mine a few times also. I had a hard time finding the white foam of the right consistency though. I would take a metal can with the correct size needed and smack the can with a block of wood while the foam was on a smooth concrete floor. The can would cut into the foam. Perfect circle.

Same here also...................