2007 dodge Ram left rear door wire harness broken wires I fix them once but they broke again. Does anyone know how to take the pins out of connector I don't have much wire to work with anymore
thanks

Here is a link to a previous thread about issues with a door harness. Towards the bottom there is mention of an aftermarket replacement harness that is available. Don't know if this will help or not. If not consider this a bump.

https://board.moparts.org/ubbthread...31098/2004-dr-dead-door.html#Post2631098

Guess I should've just linked to the part too, so here that is, but the thread discusses ways to get it a little cheaper...

https://www.dormanproducts.com/p-78790-645-506.aspx?year=2004&make=Dodge&model=Ram%25201500&parttype=Door%2520Wiring%2520Harness&origin=YMM

I was hoping someone could tell me how to take the pins out of connector and I can fix myself ..

Show us a picture of the connector and we can probably tell you how to remove the pins. There are several different style of connectors, each with its own process for removing the pins. Not all off us have a 2007 Ram to go look at. Gene

Hope this helps

Is this the female end of the plug, or the male end of the plug? Each end unlocks the wire differently. It appears to be the female end, but I can't tell for sure the way the picture is taken. Gene

Male

There is probably a spring loaded retaining tab on one side of the connector that needs to be press down so the connector will slide out, I use a small thin needle to get mine out on the earlier plugs, I push it in from the opposite side from the wire and pull on the wire while working on them, lots of fun
You can do THIS

These might be just what you need. https://www.amazon.com/Terminals-Re...or/dp/B07MV6935Q/ref=asc_df_B07MV6935Q/?