|
Re: Gen 3 to A-Body
[Re: RoadRunnerJD]
#2652722
05/06/19 07:09 PM
05/06/19 07:09 PM
|
Joined: Jan 2003
Posts: 9,982 Frostbitefalls MN (Rocky&Bullw...
gregsdart
master
|
master
Joined: Jan 2003
Posts: 9,982
Frostbitefalls MN (Rocky&Bullw...
|
I moched up a 5.7 with Jeep stainless steel stock SRT exhaust manifolds. I needed to trim the bell of the trans a touch just above the starter, and on an early A the torsion bars were right where those manifolds would exit. I put a rack and pinion and coilover system together along with coilover shocks and springs to make everything fit in the early a. There is a lot of info out there on a 69A to g3 swap, so i am certain there are easier ways to get it done than i did.
8..603 156 mph best, 2905 lbs 549, indy 572-13, alky
|
|
|
|
|
|