(Mods please put this in new products forum)

Hey all,

Just wanted to share a product we developed for the Hellcat & Demon supercharger that makes swapping a little easier.

Ours uses #10 AN ORB fittings so you can convert to AN if you want, and run it out of either side!
Meaning, you could have the inlet & outlet on different sides, or both on the driver's side if you want.

We also integrate 1/8 NPT holes into the top of them so you can stick the factory bleeder in either side.
Additionally we have a special fitting for the factory fluid temp sensor, that you can also stick on either side depending on your fluid routing or clearances.

Overall dimensions are approx 1.5" shorter than stock due to the sensor sticking out on the passenger side.
The driver's side dimensions are about the same as stock.

We offer a pair of connecting hoses as well. We don't have any outlet fittings included, because you may want a 90 degree, 45, straight, we have no idea what you want .

Just a little back story... We're currently building a 67 Barracuda with a Hellcat engine and the engine bays are smaller front to back than E/B bodies.. so I thought up this design and had our engineers draw it up! Few days later we had a 3D printed test unit, made some adjustments, and went into production. In my opinion, these are a MUST on any Hellcat swapped ride and have the ultimate flexibility!

See the pictures below. We have sold a number of these since our batch was completed last August, had them on a car at SEMA, and if you guys have seen that Hellcat Miata on Youtube that's going on right now, they have a set too!

They're in stock and ready to ship!

For more info or to order, visit this link: SCHWARTZ PERFORMANCE BILLET HELLCAT INTERCOOLER ADAPTERS

Doesnt someone already make these already????

There are similar products on the market since we designed ours, but not with our water temp sensor adapter and universal design.

Looks to be a well designed piece, thank you for posting this.

Can you tell us the dimension from the rear mounting face of the blower to the rear face of your manifold?
Thank you

Ill can measure for you in a couple days. I just ordered this set-up for the Charger were building.
Definitely needed, broke the sensor off last night test fitting.

There were similar products on the market BEFORE you designed yours....

The answer is 1.75". There are products on the market that are lower profile than that.

The correct answer was “yes, someone does, and we copied them”.

SDG Motorsports invented them and was the first to go to market.

Yep

I'll 3rd that