Rob just spun real bad again on his final qualifying pass. I hope hey get her figured out for eliminations.

This race is sold out and the gates are closed to spectators. How many times do you hear this happening at a drag strip.

This grudge racing is my hands down favorite and makes NHRA look lame as it has been 4 years............LOVE IT!!!!!!!!!!!!!

I am siding with Eric Dillard (owner of PLR) cars spinning are set up for cooler temps. Why change the tune when 1st round elims will be at night and you already have your # from last night. Goss should be A-OK for tonight.

This isn't grudge racing at this race. Small tire racing at its finest.

I went to Holly Springs a couple years ago to the spring race. Unbelievable atmosphere. I don't how anyone could go to one of the big drag radial races and not leave a fan of 1/8 mile racing. Cars that can cover the 1/8 in four seconds or less at 200 mph are bad a$$ and the guys that wheel them have a wheel barrow load size sack.

Same difference to me as far as excitement ...........

Totally different. Grudge racing is bragging about how fast your car is then turning around and asking for a head start. Small tire racing is lining them up and the light flashes. First one to the finish line wins without all the BS of grudge racing

10k people online watching as well, probably more as the night goes on

Yep. I wish the guys at my local track were watching, probably dont even know it exists, so they could learn the art of "Track Prep". You need more than a freakin power broom to have a good surface.....

[quote=pittsburghracer]This race is sold out and the gates are closed to spectators. How many times do you hear this happening at a drag strip. [/q
Especially an NHRA bracket race, not hating but I was just discussing this with a neighbor this morning bout I'll local track being a NHRA certified track and not packing the stands for there races..........Lol

I am watching online and watched the x 275 runs... but no challenger. did he break earlier?
Have yet to see a single Mopar run.

was it qualifying? he might be sitting on his previous time

X 275 first round has just started.

Marty took out Mills first round.

Yep, ran a 4.05 or 4.06 I think. I've
Been watching the live feed also, you just get bits and pieces unless stay with it. Too many people for me to go over there!!!

Rob Goss is getting three good blocks made. There will be two cast aluminum blocks and a billet block. Was just talking to him today about them.

This is the reason the after market doesn't what to produce blocks for the mopar people, there will always be a threat.... J/K

I would like to see the info on this!
Any way of looking further?
Thanks Matt

It's a done deal, should be out in a few months. They will carry Mopar part numbers and be sold threw Mopar.