|
Small Block Main Cap Question
#1944518
11/03/15 07:34 PM
11/03/15 07:34 PM
|
Joined: Jan 2003
Posts: 6,139 Melbourne , Australia
LA360
OP
master
|
OP
master
Joined: Jan 2003
Posts: 6,139
Melbourne , Australia
|
Does anyone have a main cap for a 318-340 on hand? Can you tell me the distance from the bottom of the cap to the top on the face the main bolt/stud clamps too?
Thanks in advance
Alan Jones
|
|
|
Re: Small Block Main Cap Question
[Re: LA360]
#1945100
11/04/15 05:50 PM
11/04/15 05:50 PM
|
Joined: Dec 2005
Posts: 11,552 Fulton County, PA
CMcAllister
Mr. Helpful
|
Mr. Helpful
Joined: Dec 2005
Posts: 11,552
Fulton County, PA
|
2.280" from the base (bulkhead) surface to the machined bolt face, measured at the bolt hole centerline. 1.020" thick. Main cap on a 70 340 block.
If the results don't match the theory, change the theory.
|
|
|
|
|
|