|
|
Ill be doing CB to my lights and ?
#1639186
06/27/14 07:08 PM
06/27/14 07:08 PM
|
Joined: Jan 2003
Posts: 21,063
Niles , Ohio
therocks
OP
oh wait.but hey.lets see.oh yeah.
|
OP
oh wait.but hey.lets see.oh yeah.
Joined: Jan 2003
Posts: 21,063
Niles , Ohio
|
Just checked the lights on the 65.With them on I have about 8 volts to the bulbs on both sides and both hi/low.I have Batt voltage when I pull the bulk head conn from inside.Look decent inside and no corrosion.My question is do you run a 4 pin relay?The 65 has single lights.I always thought the low powered on both dim and high also.Just have power to one wire on each side.When I go to the other only one wire has power on each side.Rocky
Last edited by therocks; 06/27/14 07:10 PM.
Chrysler Firepower
|
|
|
Re: Ill be doing CB to my lights and ?
[Re: therocks]
#1639187
06/27/14 07:37 PM
06/27/14 07:37 PM
|
Joined: Sep 2007
Posts: 14,889
up yours
Supercuda
About to go away
|
About to go away
Joined: Sep 2007
Posts: 14,889
up yours
|
Only thing used in common between high and low is the ground. Stock setup either the high or the low beam is on, not both. So you need two relays. You can set it up to run both high and low when the high beams are on.
Last edited by Supercuda; 06/27/14 07:38 PM.
They say there are no such thing as a stupid question.
They say there is always the exception that proves the rule.
Don't be the exception.
|
|
|
Re: Ill be doing CB to my lights and ?
[Re: 340SHORTY]
#1639189
06/27/14 10:24 PM
06/27/14 10:24 PM
|
Joined: Jan 2003
Posts: 21,063
Niles , Ohio
therocks
OP
oh wait.but hey.lets see.oh yeah.
|
OP
oh wait.but hey.lets see.oh yeah.
Joined: Jan 2003
Posts: 21,063
Niles , Ohio
|
I found the diagram for the wiring in archives.Pretty easy.Just hope the wiring from the bulk head to the lights is good.I do have another harness at the other house I can use though.Rocky
Chrysler Firepower
|
|
|
|
|
|
|
