Mearsuring TQ convertor? - Moparts Forums

Register Log In Moparts Forums Moparts Question and Answer Mearsuring TQ convertor?

Print Thread

Mearsuring TQ convertor? #1543716 12/04/13 03:51 PM 12/04/13 03:51 PM
Joined: Jan 2003 Posts: 2,165 Inver Grove Heights MN 7 74RR OP top fuel
74RR OP top fuel 7 Joined: Jan 2003 Posts: 2,165 Inver Grove Heights MN	What's the proper way to physically measure a TQ convertor? From teeth to teeth or measure just the body of the convertor? I'm looking at one that measures 9.5' on the body and a little under 12' across the teeth. Thanks.

Re: Mearsuring TQ convertor? [Re: 74RR] #1543717 12/04/13 04:01 PM 12/04/13 04:01 PM
Joined: Jan 2003 Posts: 20,158 Park Forest, IL slantzilla Too Many Posts
slantzilla Too Many Posts Joined: Jan 2003 Posts: 20,158 Park Forest, IL	Sounds like a 9-1/2" Dynamic. You measure the body. "Everybody funny, now you funny too."

Re: Mearsuring TQ convertor? [Re: slantzilla] #1543718 12/04/13 04:18 PM 12/04/13 04:18 PM
Joined: Jan 2003 Posts: 2,165 Inver Grove Heights MN 7 74RR OP top fuel
74RR OP top fuel 7 Joined: Jan 2003 Posts: 2,165 Inver Grove Heights MN	Thanks!

Re: Mearsuring TQ convertor? [Re: 74RR] #1543719 12/04/13 07:46 PM 12/04/13 07:46 PM
Joined: Jan 2003 Posts: 25,729 Rio Linda, CA John_Kunkel Too Many Posts
John_Kunkel Too Many Posts Joined: Jan 2003 Posts: 25,729 Rio Linda, CA	The 727 ring gear diameter will always be the same diameter but, when measured across the bowl, most converters won't actually measure their advertised diameter. The INTERNET, the MISinformation superhighway

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1