Re: Valley Cover for low deck (9 inch) R-3 Block
[Re: 340Cuda]
#1265440
07/11/12 12:41 AM
07/11/12 12:41 AM
|
Joined: Jun 2003
Posts: 52,972 Romeo MI
MR_P_BODY
Master
|
Master
Joined: Jun 2003
Posts: 52,972
Romeo MI
|
Quote:
I have a Mopar valley cover that could be cut down to work on a low block, however I would rather save it for a 9.56 block I have.
Does anyone sell a ready to run valley cover for a R-3 with a 9" deck?
Thanks, Bill
I couldnt find any to buy... so I milled my own 3/8 thick but milled the center out thinner
|
|
|
Re: Valley Cover for low deck (9 inch) R-3 Block
[Re: 340Cuda]
#1265444
07/13/12 03:49 PM
07/13/12 03:49 PM
|
Joined: Jun 2003
Posts: 52,972 Romeo MI
MR_P_BODY
Master
|
Master
Joined: Jun 2003
Posts: 52,972
Romeo MI
|
Quote:
Mike, So a flat plate will seal okay, it does not need to be angled on the head side like the Mopar part? Thanks, Bill
It needs the angle... I milled each side to give me the proper width so it lays on each head and the top of the valley I should have taken a pic when I had it finished but I forgot
|
|
|
Re: Valley Cover for low deck (9 inch) R-3 Block
[Re: SB412DUSTER]
#1265448
07/17/12 11:37 PM
07/17/12 11:37 PM
|
Joined: Apr 2003
Posts: 3,512 Tulsa, Oklahoma
340Cuda
OP
master
|
OP
master
Joined: Apr 2003
Posts: 3,512
Tulsa, Oklahoma
|
Quote:
I made mine out of 1/8 aluminum but later had to put screws in the sides to help keep it sealed to the head
Thanks, I understand Kent Ritter makes them but I have not had time to call him yet. Bill
|
|
|
Re: Valley Cover for low deck (9 inch) R-3 Block
[Re: SB412DUSTER]
#1265449
07/18/12 12:06 AM
07/18/12 12:06 AM
|
Joined: Jun 2003
Posts: 52,972 Romeo MI
MR_P_BODY
Master
|
Master
Joined: Jun 2003
Posts: 52,972
Romeo MI
|
Quote:
I made mine out of 1/8 aluminum but later had to put screws in the sides to help keep it sealed to the head
The first one I made was 1/8" alum it started leaking also thats when I made the 3/8" billet one
|
|
|
|
|