8 3/4" rear end failures - Moparts Forums

Register Log In Moparts Forums Best of Moparts / Tech Archive 8 3/4" rear end failures

Print Thread

Page 2 of 2

1

2

Re: 8 3/4" rear end failures #10597 05/07/04 02:42 PM 05/07/04 02:42 PM
Joined: Jan 2003 Posts: 4,573 ...gently down the stream LAR_414 master
LAR_414 master Joined: Jan 2003 Posts: 4,573 ...gently down the stream	Quote: What's the opinion on the MW caps? One, both ? BOTH. Stress is stress.

Re: 8 3/4" rear end failures [Re: LAR_414] #10598 05/07/04 03:07 PM 05/07/04 03:07 PM
Joined: Jan 2003 Posts: 803 Texas B Beeracuda super gas
Beeracuda super gas B Joined: Jan 2003 Posts: 803 Texas	We put them on both sides, but most everyone I've spoken to only replaces one.

Re: 8 3/4" rear end failures [Re: LAR_414] #10599 05/07/04 03:08 PM 05/07/04 03:08 PM
Joined: Jan 2003 Posts: 9,982 Ansonia, CT C CJK440 master
CJK440 master C Joined: Jan 2003 Posts: 9,982 Ansonia, CT	Stupid question about 489 crush sleeves. I don't see how they could fail??? The tapered bearings want to spread away from the sleeve at any load right??. That being said I do have a solid spacer in my 489. Mostly because it was easier to setup. I assume all the 8 3/4 success/carnage stories are on slicks???? 2017 Contusion Blue Challenger T/A 392 M6 "BLKNBLU"

Page 2 of 2

1

2

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1