I'm thinking of going pro charger in the next couple of years & was thinking making it port injection efi. I have this idea in my head of using a dual 4bbl low rise manifold, weld stubs onto the ports to drill out for the injectors, make a plenum box over the top of the carb flanges & adapting a throttle body on the front. Edlebrock make a manifold that i quite like, except its for an RB motor & i have a B block. So, not being afraid of fabricating my own parts, I was wondering if my plan is fessible. I have my own gear to port heads so i could cut open all the plenum space under the carb flanges to make a bigger plenum, do any pro chager guys on here think this is a project worth persueing? I just dont want an agricultural bent pipe poking into the top of my carb. my engine already sits quite high, i'm trying to keep it low & stealthy. Opinions from any that know are greatly appreciated.