Originally Posted By JohnRR
Originally Posted By Quicksilver440
Originally Posted By JohnRR
Originally Posted By Quicksilver440
Anyone ever seen this? I just mocked up two different bell housings I have with an 833 o.d. 4 speed I have and the drivers side bottom bolt hole on the trans is off maybe 3/8" or so. See pics....


I can't see the picture here at work.

Is this the bell housing I sold you ? It had an alum 833 bolted to it when I found it at the junkyard ????


Yep....I don't think the bell is off...it looks like it matches a BigBlock one I have. I think the hole in the trans if off a little.


Did you take measurements of holes between the 2 ?

Do you have another trans case , or another bell ? either way take measurements between the 2 of whatever you have .


I actually do have another trans case (empty) and another bell...I'll measure both just to document the difference. If you see my post above...I think Blown340 got it right...I think it's a GM version of the 833 with the saginaw bolt pattern. I actually have an empty cast iron '75 833 O.D. mopar trans case here that I bought awhile back to swap these internals into to beef up the O.D. a little.

Last edited by Quicksilver440; 12/29/15 07:29 PM.