Bench bleeding MC - is this normal?

Print Thread

Re: Bench bleeding MC - is this normal? [Re: 68red440] #1804951 04/16/15 02:19 PM 04/16/15 02:19 PM
Joined: Dec 2003 Posts: 329 Cincinnati, OH 6 68red440 OP enthusiast
68red440 OP enthusiast 6 Joined: Dec 2003 Posts: 329 Cincinnati, OH	Where can I buy just the brass seats for my 5621 reproduction master cylinder? I've already bought one $25 rebuild kit for this 1-year old MC. I need to clean out the MC ports again, but I'm not sure if the front piston will return properly after another disassembly & re-assembly. I believe the residual valve is the correct size for the seat. However, the bleed holes look different in the pistons that originally came with this MC and the Raybestos rebuild kit, and those look different from the factory pistons shown in The Ram Man's video. Based on the size and number of bleed holes, it seems as if these 3 piston sets would bleed at different rates. I'm supposed to drive the car on a 3 hour trip in a couple weeks, and hoping to figure this out soon. I appreciate it.

Entire Thread
Subject	Posted By	Posted
Bench bleeding MC - is this normal?	68red440	04/13/15 04:24 AM
Re: Bench bleeding MC - is this normal?	DoctorDiff	04/13/15 04:56 AM
Re: Bench bleeding MC - is this normal?	68red440	04/13/15 11:23 AM
Re: Bench bleeding MC - is this normal?	DoctorDiff	04/13/15 02:09 PM
Re: Bench bleeding MC - is this normal?	68red440	04/13/15 06:09 PM
Re: Bench bleeding MC - is this normal?	68red440	04/16/15 06:19 PM

Hop To