Posted By: OUTLAWD
TVS 2650? - 12/07/18 04:51 PM
Anyone running one? I see quite a few guys running Whipples, but not too many Magnusons...
http://www.magnusonsuperchargers.com/product-p/01-26-62-501-bl.htm
Are you putting this on a Hellcat engine? The reason I ask is there are many good choices out there. The 2650 is a good design, Edelbrock also makes one and I have personal experience with them.
Could we get some info on your engine, etc and we can possibly steer you in the right direction.
Posted By: OUTLAWD
Re: TVS 2650? - 12/10/18 08:24 PM
Not specifically related to a build...
A while back I asked Magnuson about a lower manifold for non-hellcat applications, and they indicated they didn't have one on the shelf, but I wonder if their casting protects for both hellcat and non-hellcat bolt patterns...There is a member here making adapters though.
The E-brock unit looks like it uses shrouded compressor inlet, but no jackshaft. Ive been told the un-obstructed inlet only makes a difference beyond 18k rpm.
I have worked quite a bit with the Magnuson unit in a brand X application, and its quite an impressive piece. It almost has me looking at blowers rather than hair dryers for my next project
Posted By: Dragula
Re: TVS 2650? - 12/15/18 04:53 AM
Its pretty tough to build anything G3 when you call around and nobody has any used blocks...
Posted By: dizuster
Re: TVS 2650? - 12/18/18 01:43 PM
Why are used blocks hard to find?
Why are used blocks hard to find?
Junkyard s in NY suck that's why, I usually go out to NJ or PA.