Posted By: gts95
Any machine shops in the DFW area that know Gen III HEMI? - 01/12/18 01:58 AM
I have a 2013 5.7 out of a 21k mile Charger which has a snapped rod. This is the way I purchased the car....I believe it was due to hydrolock. The motor is already out of the car.
I now have to decide whether to rebuild existing (block "appears" unscathed), go with a stroker kit to get all the forged goodies, or maybe pickup a 6.4 out of a wrecked donor (I have access to salvage auctions).
My biggest fear in building the engine is going to a shop that doesn't know their way around one, and getting something that will give me problems down the line. Cost is also a factor. The short-block and long-block options from the well-known players seem PRICEY!! Then add freight charges on top of that. I'd like to find somebody local and obviously live in a big Metroplex.
Can I save decent money by building up a stroker using my existing hardware like the block and heads?
Thank you for any opinions
I now have to decide whether to rebuild existing (block "appears" unscathed), go with a stroker kit to get all the forged goodies, or maybe pickup a 6.4 out of a wrecked donor (I have access to salvage auctions).
My biggest fear in building the engine is going to a shop that doesn't know their way around one, and getting something that will give me problems down the line. Cost is also a factor. The short-block and long-block options from the well-known players seem PRICEY!! Then add freight charges on top of that. I'd like to find somebody local and obviously live in a big Metroplex.
Can I save decent money by building up a stroker using my existing hardware like the block and heads?
Thank you for any opinions