Posted By: cagebob1
Megasquirt wiring question - 06/10/17 06:26 PM
Hooking up my MSPRO on my Hemi and I have a question for those with experience in these matters. The CKP sensor ...MS wiring diagram calls for 12 volt switched power, while the factory uses 5 volt reference. Will the factory sensor live on 12 volts? will MS function properly if I use the 5 volt reference for power to this(and the CMP) sensor?
Thank You
Posted By: Bad340fish
Re: Megasquirt wiring question - 06/11/17 04:37 AM
Not a Gen III car but I am using 5v for my crank sensor and cam sensor on my MS3X injected small block. No issues there.
Posted By: GoodysGotaCuda
Re: Megasquirt wiring question - 06/11/17 03:39 PM
Make sure your diagram or whatever you are referencing is the latest revision. I am pretty sure it needs 5v, I would definitely hesitate putting 12v to any engine sensor.
Posted By: ntstlgl1970
Re: Megasquirt wiring question - 06/12/17 06:23 AM
Pretty sure I'm using 5v reference on mine.
Posted By: Uhcoog1
Re: Megasquirt wiring question - 06/12/17 09:44 PM
Use the 5v. I used 5v on my ms3x, as directed by diyautotune.
My wiring is all posted here (and the 12v ref is on this diagram as well, but NOT what I did)
My link:
http://www.forabodiesonly.com/mopar/threads/how-to-megasquirt-your-3g-hemi.226125/Diyautotune link:
https://www.diyautotune.com/support/tech/install/chrysler-dodge/megasquirt-your-hemi/Who did you buy from? What did they say?
Posted By: cagebob1
Re: Megasquirt wiring question - 06/13/17 12:01 AM
Purchased from diyautotune, the 12v reference didn't sound right to me ... that's why I posted the question. Based on the replies, I have connected crank,cam, and tps sensors to 5v reference voltage circuit. Thank You to all that have replied. Can't wait to fire this thing up!