Firm Feel LCA sway bar tabs

Anyone use these? They look to be a bolt-in solution, which I'm not averse to if they work well. I intend to install a larger than stock bar. Easier than hunting down a LH LCA.

Problems? Concerns?

I'd like to see what they look like.

Best I can find, unfortunately.

Similar to the setup Addco uses, but beefier. The Addco "bracket" is just L shaped with no reinforcements. I've run Addco bars for years.

FF builds quality stuff. I don't think you'll have a problem.

Ditto on Supercuda and lilcuda's assessments.

You could weld them on instead of bolting on.

Thanks guys, as I expected to hear regarding FF.

I could definitely weld them, but am looking for some 1st hand experience from someone who has done a home bole in install and flogged them.

I'm going with a stock sway bar (for now) but want to be sure it'll hold up to a big fat one later on with the bolt in config. Otherwise, will weld.

I have a helwig sway bar on my car with the bolt on tabs. I'm going to weld mine on. They do pivot on the bolt. Not sure if it makes a difference or not but the factory welded them, so I will too.

Are not factory LCA with sway bar provisions part of the LCA stamp?

EDIT: forget it, they are welded... my bad!