Posted By: BradH
Indy CNC 295 SR or EZ Min Cross Section Area (MCSA)? - 11/21/11 06:33 PM
Anyone on here able to provide a fairly accurate Minimum Cross-Section Area (MCSA) measurement for an Indy SR or EZ w/ ICH's CNC 295 cc porting? I'm curious how it compares to my CNC-ported Victors that show pretty simmilar flow #s but "should" (based on not being taken out to Max Wedge-sized entries) have a bit better velocity.
FWIW, the MCSA I measured on the Victors yesterday is 3.05", although it gets quite a bit bigger as the runner opens up into the bowl over the short turn.
FWIW, the MCSA I measured on the Victors yesterday is 3.05", although it gets quite a bit bigger as the runner opens up into the bowl over the short turn.
